These standard cold-formed electrodes are bent from straight electrodes (some after added machining) and have the same hardness and conductivity. They outlast, many times over, the old cast and forged electrodes of similar geometry, which are impossible to cool adequately.

The table shows a wide range of electrodes generally available from stock. For sizes not shown, refer to the diagrams and description key at the bottom of the page, and order what you need. All measurements will be accurate. However, over-all length, in 1/8-in. multiples, will be held to within 1/16-in.

Tapers, water holes, and nose designs are the same as the standard straight electrodes in this catalog. Water tubes can be furnished.

Standard nose designs other than those shown here may be furnished on short order. Follow the “Key to Description”, using a ‘B’ for Dome nose, ‘C’ for flat nose, ‘E’ for truncated cone, and ‘F’ for radius nose.

Special Order Information: