Home  |  Distributors  |  Sales Territory Map  |  Capital Goods  |  Contact Us

Equa-Press Lower Holders and Electrodes

A lower, fixed, dual tip holder is offered for use with Equa-Press Holders. Like the Equa-Press, it has a standard two-inch tip spacing and helps make two welds at once, precisely alike. The standard trans-verse bar electrode shown is used when work geometry doesn't require tips on the lower side. They are water-cooled.

36.0.0.jpg

Standard Lower Electrode
36.1.1.jpg
Standard Lower Electrode
Part NumberPart DescriptionShank Diameter (in)
    D
350-4020 4020 1
350-4021 4021 1 1/4
350-4022 4022 1 1/2
Standard Lower Holder
36.2.1.jpg
Standard Lower Holder
Part NumberPart DescriptionShank Diameter (in)Tip SpacingRWMA Taper No.
    D A T
350-4030 4030 1 2 5RW
350-4031 4031 1 1/4 2 5RW
350-4032 4032 1 1/2 2 5RW
Special Lower Holder
36.3.1.jpg
Special Lower Holder
Part NumberPart DescriptionShank Diameter (in)Tip SpacingRWMA Taper No.Body Width (in)
    D A T W
350-4030-3 4030 with 1 1/4" to 2 7/8" centers 1 1 1/4" to 2 7/8" 4RW or 5RW 4
350-4031-3 4031 with 1 1/4" to 2 7/8" centers 1 1/4 1 1/4" to 2 7/8" 4RW or 5RW 4
350-4032-3 4032 with 1 1/4" to 2 7/8" centers 1 1/2 1 1/4" to 2 7/8" 4RW or 5RW 4
350-8030-6 8030 with 3" to 6" centers 1 3" to 6" 4RW or 5RW 8
350-8031-6 8031 with 3" to 6" centers 1 1/4 3" to 6" 4RW or 5RW 8
350-8032-6 8032 with 3" to 6" centers 1 1/2 3" to 6" 4RW or 5RW 8

When ordering, specify tip spacing 'A' and socket taper 'T'

Product Catalog © 2017 Tuffaloy Products Inc. All Rights Reserved.